The Beginner’s Guide to Printing

How to Refill Your Toner in Steps Today printing has gone a little technical with the advancement in the technological world. This has mainly been because of the introduction of laser printer toner. When you are printing and it starts to faint, it always means that the ink is almost over and therefore you should refill it. Some people always tend to think that their cartridge is worn out but it is their toner that is out. Your cartridge is always made in such a way that it will wear out after some time. Knowing the right time to add your toner is the secret to making your toner last longer. This will help to extend its life. The reason for this is because each and cartridge is made to work with a specific weight, gain size and chemical type toner. These are the specifics that will only work with that cartridge and not work with any other than the provided one. After knowing the right time when to add the toner, the other thing you have to know is how to do it. That is why you need a step guide on how to refill your ink toner. They are as follows. With your toner at hand, you will first of all need to locate or make the fill hole. Each and every cartridge has got a holding tank which holds the toner powder. Some of these cartridges have refill holes while other so not. After purchasing the refill kit you will get an instruction guide on how to do it. You will have to create a hole on your cartridge if it does not have a fill hole. You should not do this anywhere because you might end up destroying it. The hole is always supposed to be created on either ends and not in the middle, most of the times it should face up. The toner comes with the specific cartridge that it can work with. This is where the second step will be required. You will now have to pour the toner. Check if it is the right one and read the instructions on it. Check the expiry date on the toner and see if it is still good. In the toner kit, there is a funnel that you have to fit in the toner cup when you are pouring so that you do not spill the toner powder.
Where To Start with Printing and More
The last and third step is to release the fill hole. If your cartridge is that which has a hole, you will have to return the cup to cover the hole. Cartridges that you make holes in them before the refill comes with a specific aluminum plate that you will use for that particular job. The use of that tape is to cover the hole. You will now shake the cartridge gently so that it evenly distribute toner. You will then reinsert to the printer and continue with your printing job.What Has Changed Recently With Services?